Table of Contents
Advertisement
show pxf xcm
Table 4-14
Table 4-14 show pxf xcm Field Descriptions
Field
The following fields appear for each PXF processor
Toaster 0, Toaster 1
Number of Columns
Proc ID:
ASIC Revision
The following fields appear for each XCM memory column
XCM type
ECC is enabled for column
XCM Control Register and
Exception Type Register
Number of ECC single bit errors Identifies the number of single-bit errors that have been detected in
The following example shows the error message that is displayed when this command is used on a PRE1
module:
Router# show pxf xcm
ECC is not supported for this revision
Router#
Related Commands
Command
clear pxf
debug pxf
show pxf cable
show pxf cable
interface
show pxf cpu
show pxf dma
show pxf microcode
Cisco Broadband Cable Command Reference Guide
4-90
describes the fields displayed by the show pxf xcm command.
Description
Identifies the PXF processor.
Identifies the number of memory columns on the PXF processor.
Each PXF processor contains 4 columns of memory.
Identifies the type of processor (TMC=Toaster Memory Column).
Identifies the internal version number of the PXF processor.
Identifies the type and size, in bytes, of memory used in this
particular column.
Identifies whether ECC checking is enabled or disabled for this
memory column.
Identifies the contents of these two registers for the memory
column.
the A and B banks of memory
Description
Clears the direct memory access (DMA) and error checking and correcting
(ECC) error counters on the PXF processor.
Enables debugging of the PXF subsystems on the active PRE1 module on
the Cisco uBR10012 router.
Displays information about the multicast echo and packet intercept features
for one or all cable interfaces.
Displays information about a particular service ID (SID) on a particular
cable interface.
Displays the display different statistics about the operation of the CPU
processor during PXF processing.
Displays information for the current state of the PXF DMA buffers, error
counters, and registers.
Displays identifying information for the microcode being used on the
processor.
Chapter 4
Commands for the Cisco uBR10012 Router
OL-1581-08
Advertisement
Table of Contents
