Table of Contents
Advertisement
cable upstream shutdown
cable upstream shutdown
To disable a single upstream port, use the cable upstream shutdown command in cable interface
configuration mode. To enable the upstream port, use the no form of this command.
Syntax Description
n
Defaults
Upstream port enabled
Command Modes
Interface configuration (cable interface only)
Command History
Release
11.3 XA
Usage Guidelines
The cable upstream shutdown command shuts down a single upstream port without affecting any of
the other upstream or downstream ports on the cable interface. To shut down the entire interface, use the
shutdown command in cable interface configuration mode.
Examples
The following example shows how to disable the upstream port:
router(config-if)# cable upstream 0 shutdown
Related Commands
Command
shutdown
Cisco Broadband Cable Command Reference Guide
2-348
cable upstream n shutdown
no cable upstream n shutdown
Specifies the upstream port number. Valid values start with 0 for the first
upstream port on the cable interface line card.
Modification
This command was introduced.
Chapter 2
Description
Shuts down (disables) an interface and all of its ports.
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
