Table of Contents
Advertisement
Chapter 2
Cisco CMTS Configuration Commands
Examples
The following example shows how to enable the use of Layer 2 tunnels and then map specific CMs to
specific PVCS:
Router# config terminal
Router(config)# cable l2-vpn-service atm-vc
Router(config)# cable vc-map 0007.0e03.69f9 ATM2/0 1/1
Router(config)# cable vc-map 0010.7bed.9c95 ATM2/0 1/2
Router(config)# exit
Router#
The following example shows the same configuration as above, but with the addition of a customer name
that identifies the customer that is using each particular PVC:
Router# config terminal
Router(config)# cable l2-vpn-service atm-vc
Router(config)# cable vc-map 0007.0e03.69f9 ATM2/0 1/1 ENTERPRISE-CO1
Router(config)# cable vc-map 0010.7bed.9c95 ATM2/0 1/2 ENTERPRISE-CO2
Router(config)# exit
Router#
Related Commands
Command
cable l2-vpn-service
atm-vc
debug cable l2-vpn
show cable l2-vpn vc-
map
OL-1581-08
Description
Enables the use of Layer 2 tunnels for the Customer Premises Equipment
(CPE) traffic that is behind cable modems, so that individual CPE traffic can
be routed to a particular PVC on an ATM interface.
Displays debugging messages for the Layer 2 mapping of cable modems to
a particular PVC on an ATM interface.
Displays the mapping of one or all cable modems to PVCs on the ATM
interfaces.
Cisco Broadband Cable Command Reference Guide
cable vc-map
2-359
Advertisement
Table of Contents
