Table of Contents
Advertisement
show interface cable intercept
show interface cable intercept
To display the CMs for which traffic is currently being intercepted and forwarded to a data collector, use
the show interface cable intercept command in privileged EXEC mode.
Syntax Description
slot/port
slot/subslot/port
Command Modes
Privileged EXEC
Command History
Release
12.0(5)T1
12.0(6)SC
12.1(2)EC
12.2(4)BC1
Examples
The following shows a display after a CM has been added to the intercept list:
router# configure terminal
router#(config) interface c6/0
router(config-if)# cable intercept 0080.fcaa.aabb 10.12.13.8 512
router(config-if)#
router(config)# exit
router# show interface c6/0 intercept
MAC Address
0080.fcaa.aabb
router#
The following shows a display when no CMs have been added to the intercept list:
router# show interface c6/0 intercept
No interception active
router#
Cisco Broadband Cable Command Reference Guide
3-212
show interface cable {slot/port | slot/subslot/port} intercept
Identifies the cable interface and downstream port on the Cisco uBR7100
series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can be 0
or 1, depending on the cable interface.
Identifies the cable interface on the Cisco uBR10012 router. The following
are the valid values:
•
•
•
Modification
This command was introduced.
This command was introduced on the 12.0 SC train.
This command was introduced on 12.1 EC train.
This command was introduced on the 12.2 BC train.
exit
Destination
IP Address
3.12.13.8
slot = 5 to 8
subslot = 0 or 1
port = 0 to 4 (depending on the cable interface)
Destination
UDP Port
512
Chapter 3
Cisco CMTS Show Commands
OL-1581-08
Advertisement
Table of Contents
