Table of Contents
Advertisement
Appendix A
Using the ROM Monitor
repeat
To repeat a particular ROM monitor command from the history list, use the repeat command in ROM
monitor mode.
Syntax Description
number
string
count
Defaults
If given without any arguments, repeats the previous command once.
Command Modes
ROM monitor
Command History
Release
11.3 NA
12.1(5)EC
12.2(4)BC1
Usage Guidelines
The repeat command repeats one of the commands in the history list (which can contain up to 16
commands). You can specify the command to be repeated by its history number (as shown by the
command) or by a string that will match the command.
If you do not give any arguments with the command, it repeats the last command in the history list once.
The repeat command is not added to the
Note
also cannot include the repeat command on a command line that has multiple commands separated by
a semicolon delimiter.
Examples
The following example shows how to use the repeat command to execute one of the commands in the
history list:
rommon 9 > history
OL-1581-07
repeat [number [count] | string [count] ]
(Optional) Specifies the number, as listed in the
command to be repeated.
(Optional) Specifies a string to be compared against the commands in the
history
the string includes spaces, it must be enclosed within quotes.
(Optional) Specifies the number of times the command should be executed. The
default is 1.
Modification
This command was introduced on Cisco uBR7200 series routers.
Support was added for Cisco uBR7100 series routers.
Support was added for the Cisco uBR10012 router. Changes were also made
to the boot procedure after breaking into ROMMON to ensure that all
hardware and software registers are in a known state before loading the new
image.
list. The most recent command that matches the string is repeated. If
history
list, so you cannot repeat the repeat command. You
Cisco Broadband Cable Command Reference Guide
repeat
history
command, of the
history
A-33
Advertisement
Table of Contents
