Cisco SR2016T-NA Reference Manual page 818

show pxf cable interface
show pxf cable interface
To display information about a particular service ID (SID) on a particular cable interface, use the show
pxf cable command in user EXEC or privileged EXEC mode.
Syntax Description
cable x/y/z
sid
classifiers
mac-rewrite
queue
service-flow ds
service-flow us
Defaults No default behavior or values.
Command Modes User EXEC, Privileged EXEC
Command History Release
12.2(11)BC2
12.2(15)BC2
Usage Guidelines
The show pxf cable interface command displays the DOCSIS-related information for a particular
service ID (SID) on a particular cable interface.
Examples
The following example shows a typical display for SID 1 on cable interface c8/0/0 for the show pxf cable
interface classifiers command:
Router# show pxf cable interface c8/0/0 1 classifiers
CM Classifiers:
Mac Rw Index: 18
id=1, sfid=91 CFR Index 16461 RP sfindex 16461,
prio=7, sip=0.0.0.0, sip mask=0.0.0.0
dip=0.0.0.0, dip mask=0.0.0.0, prot=17, tos=0,FF
sport = 0,65535, dport = 0,65535 matches = 0
Cisco Broadband Cable Command Reference Guide
4-58
show pxf cable interface cable x/y/z sid {classifiers | mac-rewrite | queue | service-flow ds |
service-flow us}
Identifies the cable interface for which information should be displayed.
Identifies the service ID (SID) for which information should be displayed.
The valid range is 1 to 8191.
Displays the packet classifiers used for this SID.
Displays the CPE MAC information for this SID.
Displays the status of the queues being used by this SID.
Displays the service flow IDs (SFID) associated with the given SID on the
downstream for the given cable interface.
Displays the SFIDs associated with the given SID on the upstream for the
given cable interface.
Modification
This command was introduced as show hardware pxf cable for the
Cisco uBR10012 router.
This command was renamed from show hardware pxf cable interface to
show pxf cable interface.
CCB Index: 47
Chapter 4 Commands for the Cisco uBR10012 Router
OL-1581-08