Cisco SR2016T-NA Reference Manual page 522

show cable flap-list
show cable flap-list
To display the cable flap-list on a Cisco CMTS, use the show cable flap-list command in user EXEC or
privileged EXEC mode.
Syntax Description
cable slot/port
cable slot/subslot/port
upstream port
sort-interface
sort-flap
sort-int
sort-mac
sort-time
Command Modes
User EXEC, Privileged EXEC
Command History Release
11.3 NA
12.0(3)T
Cisco Broadband Cable Command Reference Guide
3-26
show cable flap-list
show cable flap-list cable {slot/port | slot/subslot/port} [upstream port] [sort-flap | sort-int | sort-
mac | sort-time]
show cable flap-list sort-interface [sort-flap | sort-int | sort-mac | sort-time]
Modification
This command was introduced.
This command was supported on the Cisco mainline release.
(Optional) Displays the flap list for a particular cable interface on the
Cisco uBR7100 series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can
be 0 or 1, depending on the cable interface.
(Optional) Displays the flap list for a particular cable interface on the
Cisco uBR10012 router. The following are the valid values:
slot = 5 to 8
•
subslot = 0 or 1
•
• port = 0 to 4 (depending on the cable interface)
(Optional) Displays the flap list for a particular upstream on the
selected cable interface.
(Optional) Displays the flap list for all cable interfaces, sorted by
interface.
(Optional) Sorts the list by the number of times the CM has flapped.
(Optional) Sorts the list first by the Cisco CMTS cable interface.
(Optional) Sorts the list first by the Cisco CMTS cable interface and
then by the CM MAC (hardware) address.
(Optional) Sorts the list by the most recent time the CM is detected to
have flapped.
Chapter 3 Cisco CMTS Show Commands
OL-1581-08