Table of Contents
Advertisement
Chapter 4
Commands for the Cisco uBR10012 Router
show cr10k-rp queue
To display information about the versatile traffic management system (VTMS) packet queues for a cable
interface, use the show cr10k-rp queue command in user EXEC or privileged EXEC mode.
Syntax Description
cable x/y/z
be
cir
llq
Defaults
No default behavior or values.
Command Modes
User EXEC, Privileged EXEC
Command History
Release
12.2(15)BC1
Usage Guidelines
The show cr10k-rp queue command displays information about the VTMS queues on the
Cisco uBR10012 router. VTMS is a predictive scheduler that uses traffic shaping and link bandwidth
usage to control the order and frequency in which output queues are serviced.
Examples
The following example shows typical displays for each form of the show cr10k-rp queue command:
Router# show cr10k-rp c8/0/0 queue be
DOCSIS Queue Allocation Status
------------------------------
DOCSIS Queues Allocated : 0 (Max 60000)
Reserved DOCSIS Queues per interface: 512
Queue Information:
------------------
BE Queues:
Router# show cr10k-rp c8/0/0 queue cir
DOCSIS Queue Allocation Status
------------------------------
OL-1581-08
show cr10k-rp cable x/y/z queue {be | cir | llq}
Identifies the cable interface for which information should be displayed.
Displays information for the best effort (BE) packet queues.
Displays information for the committed information rate (CIR) packet
queues.
Displays information for low latency packet queues (llq).
Modification
This command was introduced for the Cisco uBR10012 router.
Cisco Broadband Cable Command Reference Guide
show cr10k-rp queue
4-49
Advertisement
Table of Contents
