Table of Contents
Advertisement
debug cable-modem mac log
528438.798 CMAC_LOG_RNG_RSP_MSG_RCVD
528444.102 CMAC_LOG_WATCHDOG_TIMER
528444.492 CMAC_LOG_LINK_DOWN
528444.494 CMAC_LOG_RESET_FROM_DRIVER
528444.494 CMAC_LOG_STATE_CHANGE
528444.494 CMAC_LOG_DRIVER_INIT_IDB_SHUTDOWN
528444.494 CMAC_LOG_LINK_DOWN
528474.494 CMAC_LOG_WATCHDOG_TIMER
528504.494 CMAC_LOG_WATCHDOG_TIMER
528534.494 CMAC_LOG_WATCHDOG_TIMER
0 events dropped due to lack of a chunk
Note
The line "
entries were discarded due to a temporary lack of memory. This means the log is accurate and reliable.
The following example shows typical output of the debug cable-modem mac log verbose command.
The verbose keyword displays periodic events such as ranging.
Router# debug cable mac log verbose
Cable Modem mac log debugging is on (verbose)
Router#
574623.810 CMAC_LOG_RNG_REQ_TRANSMITTED
574623.812 CMAC_LOG_RNG_RSP_MSG_RCVD
574627.942 CMAC_LOG_WATCHDOG_TIMER
574633.880 CMAC_LOG_RNG_REQ_TRANSMITTED
574633.884 CMAC_LOG_RNG_RSP_MSG_RCVD
574643.950 CMAC_LOG_RNG_REQ_TRANSMITTED
574643.954 CMAC_LOG_RNG_RSP_MSG_RCVD
574654.022 CMAC_LOG_RNG_REQ_TRANSMITTED
574654.024 CMAC_LOG_RNG_RSP_MSG_RCVD
574657.978 CMAC_LOG_WATCHDOG_TIMER
574664.094 CMAC_LOG_RNG_REQ_TRANSMITTED
574664.096 CMAC_LOG_RNG_RSP_MSG_RCVD
574674.164 CMAC_LOG_RNG_REQ_TRANSMITTED
574674.166 CMAC_LOG_RNG_RSP_MSG_RCVD
The following example shows how to disable verbose debugging:
Router# no debug cable mac log verbose
Cable Modem mac log debugging is off
Router#
Related Commands
Command
debug cable-modem bpkm
debug cable-modem bridge
debug cable-modem error
debug cable-modem interrupts
debug cable-modem mac
messages
debug cable-modem mac
messages dynsrv
debug cable-modem map
Cisco Broadband Cable Command Reference Guide
6-194
0 events dropped due to lack of a chunk
Description
Displays information about Baseline Privacy Interface (BPI) key
management.
Displays bridge filter processing information.
Displays debugging messages for the cable interface driver.
Displays information about CM interrupts.
Displays the MAC-layer messages.
Displays the dynamic service MAC-layer messages.
Displays the timing of MAP and sync messages.
wait_for_link_up_state
0x08098D02
" at the end of the display indicates that no log
Chapter 6
Cable CPE Commands
OL-1581-07
Advertisement
Table of Contents
