Table of Contents
Advertisement
Chapter 5
Cisco CMTS Debugging Commands
The following example shows how to enable debugging messages for ARP filtering for a particular SID
on a cable interface:
Router# debug cable interface cable c5/0 sid 31
Router# debug cable arp filter
CMTS arp filter debugging is ON
Router#
Related Commands
Command
cable arp
cable arp filter
cable proxy-arp
cable arp
clear counters
debug cable arp
debug cable interface
debug cable
mac-address
show cable arp-filter
OL-1581-08
Description
Activates cable Address Resolution Protocol (ARP).
Controls the number of ARP packets that are allowable for each Service ID
(SID) on a cable interface.
Activates cable proxy ARP on the cable interface.
Clears the ARP table on the router.
Clears the packet counters on all interfaces or on a specific interface.
Enables debugging of ARP traffic on a cable interface.
Enables debugging for a particular Service ID (SID) on a specific cable
interface.
Enables debugging for a particular CM.
Displays the total number of ARP replies and requests that have been sent
and received, including the number of requests that have been filtered.
Cisco Broadband Cable Command Reference Guide
debug cable arp filter
5-9
Advertisement
Table of Contents
