Figure 12: Non-Ppp Equal-Access Configuration Example; Configuring The Router To Work With The Src Software - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide

Configuring the Router to Work with the SRC Software

E Series Broadband Services Routers have an embedded SRC client that interacts
with the SRC software. For information about configuring the SRC client, see
"Configuring the SRC Client" on page 94.
Figure 12 on page 486 shows the scenario for this example. Subscribers obtain access
Configuration Example
to ISP Boston via a router. Subscribers log in through the SRC software, and a RADIUS
server provides authentication.

Figure 12: Non-PPP Equal-Access Configuration Example

The following steps describe how to configure this scenario.
1.
486
Configuring the Router to Work with the SRC Software
Monitoring DHCPv6 Local Server Binding Information on page 567
Configure interfaces on the router.
host1(config)#interface loopback 0
host1(config-if)#ip address 10.10.1.1 255.255.255.255
host1(config-if)#ip address 10.10.2.1 255.255.255.255 secondary