Configuring a NAT License
You must configure a NAT license before you can use any NAT commands on the
ERX router.
license nat
NOTE: Acquire the license from Juniper Networks Customer Services and Support
or from your Juniper Networks sales representative.
Limiting Translation Entries
You can configure the maximum number of dynamic translation entries that the
translation table contains in global configuration mode for a given virtual router.
ip nat translation max-entries
Specifying Inside and Outside Interfaces
You must mark interfaces that participate in NAT translation as residing on the inside
or the outside network.
Use to specify a NAT license.
Purchase a NAT license to allow NAT configuration on the ERX router.
Example
host1(config)#license nat license-value
Use the no version to disable the license.
See license nat.
Use to specify the maximum number of dynamic translation entries that the
translation table can contain in global configuration mode for the given virtual
router.
Example
host:VR1 (config-if) #ip nat translation max-entries 1000
Use the no version to remove the configured limit and return the maximum
number of translation entries to the default, which is no enforced limit, as capacity
allows.
See ip nat translation max-entries.
Chapter 2: Configuring NAT
Configuring a NAT License
71