Table of Contents
Advertisement
Before You Configure IPv6
Configuring an IPv6 License
license ipv6
Copyright © 2010, Juniper Networks, Inc.
RFC 2464—Transmission of IPv6 Packets over Ethernet Networks (December 1998)
RFC 2465—Management Information Base for IP Version 6: Textual Conventions and
General Group (December 1998)
RFC 2466—Management Information Base for IP Version 6: ICMPv6 Group (December
1998)
You can access these and other Internet RFCs and drafts at the following URL:
http://www.ietf.org
Before you configure IPv6, you must create the lower-layer interfaces over which IPv6
traffic flows. For information about the modules that support IPv6:
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for modules
supported on E120 and E320 routers.
See ERX Module Guide, Appendix A, Module Protocol Support for modules supported
on the ERX310, ERX710, ERX1410, and ERX1440 routers.
For example, to configure an ATM interface:
host1(config)#interface atm 1/0
host1(config-if)#atm sonet stm-1
host1(config-if)#no loopback
host1(config-if)#atm clock internal chassis
host1(config-if)#interface atm 1/0.10
host1(config-if)#atm pvc 10 0 20 aal5snap
See JunosE Link Layer Configuration Guide for information about configuring an ATM
interface. See JunosE Physical Layer Configuration Guide for information about configuring
an Ethernet interface.
You must configure an IPv6 license before you can use any IPv6 commands on the
E Series router.
Use to specify an IPv6 license.
Purchase an IPv6 license to allow IPv6 configuration on the E Series router.
NOTE: Acquire the license from Juniper Networks Customer Services and
Support or your Juniper Networks sales representative.
Example
host1(config)#license ipv6 license-value
Chapter 2: Configuring IPv6
129
Advertisement
Table of Contents
