JunosE 11.2.x BGP and MPLS Configuration Guide
Setting a Baseline on All BGP Statistics
Related Topics
Enabling Display of BGP Logs
Related Topics
158
Monitoring Prefix List Outbound Route Filters Received from the BGP
Neighbor on page 187
Monitoring Routes Originating from a BGP Neighbor Before Application of Inbound
Policy on page 188
Monitoring Routes Originating from a BGP Neighbor After Application of Inbound
Policy on page 189
Monitoring Networks in an Autonomous System on page 191
Monitoring BGP Next Hops on page 192
Monitoring BGP Paths on page 193
Monitoring BGP Peer Groups on page 193
Monitoring BGP Routes with Matching AS-Paths and Regular Expressions for Single
Regular Expressions on page 196
Monitoring BGP Routes with Matching AS-Paths and Regular Expressions for Multiple
Regular Expressions on page 198
Monitoring the Status of All BGP Neighbors on page 200
Monitoring All Routes in a BGP Community List on page 204
Disabling Display of BGP Logs on page 205
You can set a baseline for all BGP statistics.
The system implements the baseline by reading and storing the statistics at the time the
baseline is set and then subtracting this baseline whenever baseline-relative statistics
are retrieved.
To set a baseline for BGP statistics:
Issue the baseline ip bgp command:
host1#baseline ip bgp
baseline ip bgp
To display information about BGP logs for inbound or outbound events, or both.
Issue the debug ip bgp command:
host1#debug ip bgp
Disabling Display of BGP Logs on page 205
debug ip bgp
undebug ip bgp
Copyright © 2010, Juniper Networks, Inc.