[26-10] Ingress-Policy-Name; [26-11] Egress-Policy-Name - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

[26-10] Ingress-Policy-Name

Use the following commands to manage the Ingress-Policy-Name RADIUS attribute.
radius include ingress-policy-name
radius ignore ingress-policy-name

[26-11] Egress-Policy-Name

Use the following commands to manage the Egress-Policy-Name RADIUS attribute.
radius include egress-policy-name
Example
host1(config)#radius ignore virtual-router enable
Use the no version to restore the default, disable.
radius include ingress-policy-name
radius ignore ingress-policy-name
Use to include the Ingress-Policy-Name attribute in Acct-Start or Acct-Stop
messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include ingress-policy-name acct-start enable
Use the no version to restore the default.
Use to cause the Ingress-Policy-Name attribute to be ignored in Access-Accept
messages.
You can control this behavior by enabling or disabling this command. The default
is disable.
See radius ignore
Example
host1(config)#radius ignore ingress-policy-name enable
Use the no version to restore the default, enable.
radius include egress-policy-name
radius ignore egress-policy-name
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
221