Monitoring Duplicate Ipv6 Prefixes; Monitoring Src Client Connection Status - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

Monitoring Duplicate IPv6 Prefixes

Purpose
Action
Related Topics

Monitoring SRC Client Connection Status

Purpose
Action
Copyright © 2010, Juniper Networks, Inc.
Display whether the ability to detect duplicates of IPv6 Neighbor Discovery router
advertisement prefixes and DHCPv6 delegated prefixes is enabled.
To check whether duplicate IPv6 prefix detection capability is enabled:
host1#show aaa duplicate-prefix-check
enabled
show aaa duplicate-prefix-check
Display the current status of the SRC client connection to the SAEs. The command output
refers to the SRC client by its former name, SSC client.
To display the status of the SRC client connection:
host1#show sscc info
The SSC Client configured protocols : IP(v4), DHCP(v4), L2TP(LAC)
The SSC Client is currently unconnected
The SSC Client configured servers are:
Primary: 10.10.2.2:3
Secondary: 0.0.0.0:0
Tertiary: 0.0.0.0:0
Local Source: FastEthernet 0/0, Local Source Address: 10.13.5.61
The configured transport router is: default
The configured retry timer is (seconds): 90
The configured update-policy-request is: Enabled
The connection state is: NoConnection
SSC Client Statistics:
Policy Commands received
Policy Commands(List)
Policy Commands(Acct)
Bad Policy Cmds received
Error Policy Cmds received 0
Policy Reports sent
Connection Open requests
Connection Open completed
Connection Closed sent
Connection Closed remotely 0
Create Interfaces sent
Delete Interfaces sent
Active IP Interfaces
IP Interface Transitions
Synchronizes received
Synchronize Complete sent
Internal Errors
Communication Errors
Tokens Seen
Active Tokens
Token Transitions
Token Creates Sent
Token Deletes Sent
Active Addresses
Address Transitions
Chapter 2: Monitoring and Troubleshooting Remote Access
0
0
0
0
0
0
0
0
0
0
2
0
0
0
0
0
0
0
0
0
0
0
0
147