Monitoring Transparent Bridging - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide
5.
6.
7.
8.

Monitoring Transparent Bridging

This section describes how to:
NOTE: The E120 and E320 routers output for monitor and show commands is
identical to output from other E Series routers, except that the E120 and E320 routers
output also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
440
Monitoring Transparent Bridging
Assign a unique VLAN ID to the VLAN subinterface.
host1(config-if)#vlan id 100
Configure a subscriber (client) bridge group interface over the VLAN subinterface.
Assign the interface to the bridge group you created in Step 1.
host1(config-subif)#bridge-group westford02
Exit Subinterface Configuration mode.
host1(config-subif)#exit
(Optional) Configure additional VLAN subinterfaces and bridge group interfaces
by repeating Steps 4 through 6, supplying unique values.
Set a statistics baseline for bridge groups and bridge interfaces.
Remove all dynamic MAC address entries or a specific dynamic MAC address
entry from the forwarding table for bridge groups and bridge interfaces.
Use the show commands to monitor bridge groups, bridge group interfaces, and
subscriber policies