Optional Configuration Tasks - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide

Optional Configuration Tasks

You can perform the following optional PPP configuration tasks:
ppp description
ppp ipcp lockout
ppp ipcp netmask
242
Optional Configuration Tasks
Add a text description or alias to a PPP interface.
Configure the IPCP netmask option (option 0x90).
Specify the keepalive timeout value.
Disable magic numbers.
Control validation of the LCP peer magic number when the peer has not
negotiated an LCP magic number.
Configure the maximum number of LCP, IPCP, or IPv6CP renegotiation attempts
that the router accepts before terminating a PPP session.
Specify the maximum receive units.
Configure passive mode.
Configure name server addressing.
Stop or restart a PPP session.
Configure PPP authentication.
Use to assign a text description or alias to a static PPP interface.
Example
host1(config-if)#ppp description pah8999
Use the no version to remove the description.
See ppp description.
Use to terminate invalid IPv4 subscribers and prevent additional IPCP
negotiations.
When Internet Protocol version 6 Control Protocol (IPv6CP) is active, this
command enables unused IPv4 addresses, which are allocated for the IPv6
subscribers, to be available for the IPCP services for an internally defined time
interval (10 seconds). When the time interval elapses, the subscriber must connect
again to negotiate IPCP.
Example
host1(config-subif)#ppp ipcp lockout
Use the no version to disable the IPCP lockout option on the interface.
See ppp ipcp lockout.