Siemens SINAMICS DCM Manual page 506

Figure 10-55 Properties
Make the following settings:
● Select a name to identify the drive
● Enter the IP address of the drive
● Set "Connection parameters" as described in Chapter "Implicit messaging" – cyclic
communication as I/O slave (Page 499).
After the configuration has been activated, the drive data can be accessed via the input and
output data fields (figure below).
For a better program documentation, it is recommended that aliases be defined for each
input and output signal.
Figure 10-56 Input data and output data
Now configure the drive in order to use Ethernet/IP.
SINAMICS DCM DC Converter
Operating Instructions, 02.2015, A5E34763375/RS-AA/001
ac.maher.co.ir
Descriptions of functions
10.7 EtherNet/IP
507