Siemens SINAMICS DCM Manual page 302

Figure 8-36
Accept the settings by clicking OK.
The function modules are also correspondingly set in the drive by connecting online and
downloading.
8.5.2 Activating online through parameters
Note
This process is not supported by STARTER because it uses its own mechanisms.
Activation is through p0108. r0108 and is available at each DO as a display parameter for
the activated function modules.
The setting is made on p0108[i] in the Control Unit. In this case, the index corresponds to the
DO.
Index 0 stands for the CU,
Index 1 for the first DO – the default is the closed loop control DO DC_CTRL,
Index 2 optionally the first TMxx, etc.
SINAMICS DCM DC Converter
Operating Instructions, 02.2015, A5E34763375/RS-AA/001
Selecting the function modules
ac.maher.co.ir
Commissioning
8.5 Activating function modules
303