Siemens SINAMICS DCM Manual page 271

Dc converter

Hide thumbs Also See for SINAMICS DCM:

Commissioning

8.3 Commissioning using the AOP30 operator panel

Status after commissioning

LOCAL mode (control via operator panel)

● You switch to LOCAL mode by pressing the "LOCAL/REMOTE" key.

● Control (ON/OFF) is carried out via the "ON" and "OFF" keys.

● You can set the setpoint using the "Increase" and "Decrease" keys or by entering the

appropriate numbers on the operation screen using the numeric keypad.

Resetting parameters to factory settings

The factory settings represent the defined original status of the unit on delivery.

Resetting the parameters to the factory settings means that all the parameter settings made

since the system was delivered are reset.

Setting the parameter filter to "Parameter reset"

<MENU> <Commissioning/Service> <OK> <Device commissioning> <OK> <30: Parameter

Restoring all parameters to their factory settings

All of the unit parameters are reset to their factory settings. The AOP30 is powered down

and back up again during this process.

Operating Instructions, 02.2015, A5E34763375/RS-AA/001

ac.maher.co.ir

SINAMICS DCM DC Converter