Operation
9.2 Parameterizing using the BOP20 (Basic Operator Panel 20)
Name
Hot swapping
Key operation
Overview of important parameters (refer to the SINAMICS DCM List Manual)
All drive objects
● p0005 BOP status display selection
● p0006 BOP status display mode
● p0013 BOP user-defined list
● p0971 Drive object, save parameters
Drive object, Control Unit (CU_DC)
● r0002 Control Unit status display
● p0003 BOP access level
● p0004 BOP display filter
● p0007 BOP backlighting
● p0008 BOP drive object selection
● p0009 Device commissioning, parameter filter
● p0011 BOP password input (p0013)
● p0012 BOP password confirmation (p0013)
● r0019 CO/BO: Control word, BOP
● p0977 Save all parameters
346
The BOP can be unplugged and plugged while energized.
The ON and OFF keys have a function.
•
When unplugging, the drives are stopped.
After plugging, the drives must be switched on again.
The ON and OFF keys have no function
•
Unplugging and plugging has no effect on the drives.
The following applies to the "P" and "FN" keys:
When used in a combination with another key, "P" or "FN" must be pressed before the
•
other key.
ac.maher.co.ir
Description
SINAMICS DCM DC Converter