Siemens SINAMICS DCM Manual page 360

Complete commissioning
Complete commissioning, with entry of the motor and encoder data, is carried out. Following
this, key motor parameters are recalculated on the basis of the motor data. The parameter
values calculated during the previous commissioning process are lost. The calculated values
are then overwritten during a subsequent optimization run.
Optimization run
The selection screen for the optimization runs appears.
9.3.5.2 Device commissioning
In this menu, you can enter the device commissioning status directly. This is the only way
that you can reset parameters to their factory settings, for example.
9.3.5.3 AOP settings
Control settings
This defines the settings for the control keys in LOCAL mode (see the section titled
"Operation/Operation via the operator panel") as well as additional settings that are relevant
for drive control.
Display settings
This menu is where you make the lighting, brightness, and contrast settings for the display.
Define operation screen
In this menu, you can switch between five operation screens. You can set the parameters
that are to be displayed.
Figure 9-20 Define operation screen
SINAMICS DCM DC Converter
Operating Instructions, 02.2015, A5E34763375/RS-AA/001
9.3 Controlling via the AOP30 operator panel
ac.maher.co.ir
Operation
361