Siemens SINAMICS DCM Manual page 346

Note
During a data save operation initiated by the user, the electronic power supply for the
SINAMICS DC MASTER must not be interrupted.
An active saving process is indicated by the following actions:
• The RDY LED flashes (see the "Description of functions" chapter, "Description of the
• The BOP20 flashes
Interrupting the electronic power supply while saving can lead to the loss of the actual
device parameter assignment. Also refer to Chapter "Operation", Section "Memory card
functions".
Drive object (DC_CTRL)
● p0010 Commissioning, parameter filter
9.2.2 Displays and using the BOP20
Characteristics
● Status display
● Changing the active drive object
● Displaying/changing parameters
● Displaying/acknowledging faults and alarms
● Controlling the drive using the BOP20
Status display
The operating display for each drive object can be set using p0005 and p0006. Using the
operating display, you can change into the parameter display or to another drive object. The
following functions are possible:
● Changing the active drive object
– Press the "FN" and "Arrow up" keys -> the drive object number at the top left flashes
– Select the required drive object using the arrow keys
– Confirm with the "P" key
● Parameter display
– Press the "P" key
– The required parameter can be selected using the arrow keys
– Press the "FN" key -> "r00000" is displayed
– Press the "P" key -> returns to the status display
SINAMICS DCM DC Converter
Operating Instructions, 02.2015, A5E34763375/RS-AA/001
9.2 Parameterizing using the BOP20 (Basic Operator Panel 20)
LEDs on the CUD" section)
ac.maher.co.ir
Operation
347