Siemens SINAMICS DCM Manual page 485

Descriptions of functions
10.5 Communication via PROFINET IO
Error in the parameterization/configuration/commissioning procedure
An error was identified in the parameterization or in a commissioning procedure, or the
parameterization does not match the actual device configuration. Determine the exact cause
of the error with the commissioning tool, adapt the parameterization or device configuration.
General drive fault
Group fault, determine the exact cause of the fault with the commissioning tool.
Auxiliary unit faulted
The monitoring of an auxiliary unit (incoming transformer, cooling unit, etc.) has detected an
illegal state. Determine the exact cause of the error and check the relevant device.
486
Operating Instructions, 02.2015, A5E34763375/RS-AA/001
ac.maher.co.ir
SINAMICS DCM DC Converter