Siemens SINAMICS DCM Manual page 270

Dc converter

Hide thumbs Also See for SINAMICS DCM:

Basic commissioning

Final confirmation

Confirm the parameters you have entered to save them. Once you have selected "Continue"

and activated your entries with <F5>, the parameters you entered will be permanently saved

and the calculations required for closed-loop control carried out.

Optimization runs

Perform the optimization runs one after the other:

To navigate through the selection fields, choose <F2> or <F3>.

To activate a selection, choose <F5>.

See Chapter "Drive optimization" for more details

If an optimization run is not carried out, the motor control uses the motor characteristic

values calculated from the rating plate data rather than the measured values.

During optimization runs, the drive initiates motor movements that can reach the maximum

motor speed.

The EMERGENCY OFF functions must function at the commissioning.

To protect man and machines, the relevant safety regulations must be observed.

SINAMICS DCM DC Converter

Operating Instructions, 02.2015, A5E34763375/RS-AA/001

8.3 Commissioning using the AOP30 operator panel

Current limit, torque direction I

Current limit, torque direction II

Torque limit I

Torque limit II

Ramp-up time 1

Ramp-down time 1

Initial rounding 1

Final rounding 1

Optimization of the armature current control for induction load

Optimization of the field current control

Optimization of the armature current control

Optimization of the speed control

Optimization of the EMF control (incl. field characteristic recording)

Recording of the friction characteristic

Optimization of the speed control for drives with a mechanical system capa-

ble of oscillation

ac.maher.co.ir

Commissioning