Siemens SINAMICS DCM Manual page 311

Commissioning
8.6 Commissioning optional additional modules
8.6.3.2 Adding offline in STARTER
Figure 8-43
8.6.3.3 Deleting from the drive online
Deleting a CBE20 without STARTER always leads to the loss of the parameter assignments
which are replaced by the factory settings.
p0009=30
p0976=1
(re-commissioning)
8.6.3.4 Deleting offline with STARTER
In STARTER, the Control Unit configuration wizard can also be used to subsequently add or
remove a CBE20 (see Adding offline in STARTER).
After deleting in the wizard, the project needs to be saved, loaded into the drive and
permanently saved with RAM→ROM.
312
Configuration
ac.maher.co.ir
SINAMICS DCM DC Converter
Operating Instructions, 02.2015, A5E34763375/RS-AA/001