Siemens SINAMICS DCM Manual page 289

Commissioning
8.4 Commissioning with the STARTER commissioning tool
Encoder data - Freely wired actual value
⇒ Enter the source with the actual value for the closed-loop controller via the BICO
interconnection.
⇒ Click Next >
Encoder data – Encoder on the SMC30 evaluation module
Figure 8-24 Entering the encoder data (DRIVE-CLiQ)
⇒ Enter the encoder type (usually HTL/TTL), the number of pulses per revolution, the level
and the zero mark configuration
⇒ Click Next >
290
Operating Instructions, 02.2015, A5E34763375/RS-AA/001
ac.maher.co.ir
SINAMICS DCM DC Converter