Siemens SINAMICS DCM Manual page 482

Overview of important parameters (see SINAMICS DCM List Manual)
• p8835
• r8858[0...39]
10.5.6.1 EtherNet/IP
SINAMICS DCM supports the communication with the fieldbus EtherNet Industrial Protocol
(EtherNet/IP or also EIP). EtherNet/IP is an open standard based on Ethernet, which is
predominantly used in the automation industry. EtherNet/IP is supported by the Open
DeviceNet Vendor Association (ODVA).
For communication with EtherNet/IP, an Ethernet CBE20 option board is required. By setting
p8835 = 4, you can choose the communication profile EtherNet/IP. After POWER ON, the
profile becomes active.
10.5.7 Messages via diagnostics channels
Messages can be displayed not only via the well-known commissioning tools (STARTER,
SCOUT). After the activation of a diagnostic function, the messages are also transferred to
the higher-level controller via the standardized diagnostic channels. The messages are
evaluated there or forwarded for convenient display to the corresponding user interfaces
(SIMATIC HMI, TIA Portal, etc.). The messages are shown on the respective user interfaces
similarly as in STARTER.
In this way, problems or faults can be located immediately regardless of the tool currently
being used, and then corrected immediately. No further tools must therefore be called for the
correction.
SINAMICS DCM DC Converter
Operating Instructions, 02.2015, A5E34763375/RS-AA/001
CBE20 firmware selection
COMM BOARD read diagnostics channel
ac.maher.co.ir
Descriptions of functions
10.5 Communication via PROFINET IO
483