Siemens SINAMICS DCM Manual page 309

Commissioning
8.6 Commissioning optional additional modules
● Continue to the "Encoder" screen and activate the second encoder there
Figure 8-42
● Use the "Encoder data" button to enter the data of this encoder.
● If you also want to use the encoder connected to the SMC30 as the actual value for the
speed controller, you have to select as the source for the actual value "5: DRIVE-CLiQ
encoder".
● Run through the wizard until the end and load the expanded project into the drive.
310
Activating the second encoder
ac.maher.co.ir
SINAMICS DCM DC Converter
Operating Instructions, 02.2015, A5E34763375/RS-AA/001