Siemens SINAMICS DCM Manual page 267

Commissioning
8.3 Commissioning using the AOP30 operator panel
Selecting the language
When the system is first powered up, a screen for selecting the language appears.
Once the language has been selected, the powering-up process continues.
Once the system has successfully powered up, the drive has to be commissioned when the
system is switched on for the first time after it has been delivered. The converter can then be
switched on.
When the system is then powered up again, it can be operated immediately.
Navigation within the dialog screens
Within a dialog screen, the selection boxes can usually be selected using the <F2> and/or
<F3> keys. Selection boxes are generally texts surrounded by a frame. When they are
selected, they are highlighted by means of white text on a black background.
The current value of a highlighted selection box can usually be changed by pressing <F5>
"OK" and/or "Change". Another entry field then appears; the value you want can be entered
directly in this using the numerical keypad or can be selected from a list.
In the wizard, you can change from a dialog screen to the next or previous screen by
selecting the "Continue" or "Back" selection boxes and then confirming by pressing <F5>
"OK".
If a screen contains particularly important parameters, the selection box "Continue" only
appears at the bottom of the screen. This is because every single parameter in this dialog
screen has to be checked thoroughly and/or corrected before the next screen can be
accessed.
8.3.1.2 Full drive commissioning
Adjust the rated device currents
Note
The US rating must be set at p50067 for Base Drives (type 6RA80xx-2xxxx) manufactured in
North America.
The rated armature DC current for the device must be adjusted by setting p50076[0] (in %)
or p50067 if:
268
You can select the language in the dialog
screen.
To change the language, use <F2> or <F3>.
To select the language, use <F5>.
Operating Instructions, 02.2015, A5E34763375/RS-AA/001
ac.maher.co.ir
SINAMICS DCM DC Converter