Interrupts - Renesas F-ZTAT H8 Series Hardware Manual

10.3.7

Interrupts

SCI3 has six interrupt sources: transmit end, transmit data empty, receive data full, and the three
receive error interrupts (overrun error, framing error, and parity error). All share a common
interrupt vector. Table 10.16 describes each interrupt.
Table 10.16 SCI3 Interrupts
Interrupt Description
RXI Interrupt request due to receive data register full (RDRF)
TXI Interrupt request due to transmit data register empty (TDRE)
TEI Interrupt request due to transmit end (TEND)
ERI Interrupt request due to receive error (OER, FER, or PER)
The interrupt requests are enabled and disabled by bits TIE and RIE of SCR3.
When bit TDRE in SSR is set to 1, TXI is requested. When bit TEND in SSR is set to 1, TEI is
requested. These two interrupt requests occur during data transmission.
The initial value of bit TDRE is 1. Accordingly, if the transmit data empty interrupt request (TXI)
is enabled by setting bit TIE to 1 in SCR3 before placing transmit data in TDR, TXI will be
requested even though no transmit data has been readied.
Likewise, the initial value of bit TEND in SSR is 1. Accordingly, if the transmit end interrupt
request (TEI) is enabled by setting bit TEIE to 1 in SCR3 before placing transmit data in TDR,
TEI will be requested even though no data has been transmitted.
These interrupt features can be used to advantage by programming the interrupt handler to move
the transmit data into TDR. When this technique is not used, the interrupt enable bits (TIE and
TEIE) should not be set to 1 until after TDR has been loaded with transmit data, to avoid
unwanted TXI and TEI interrupts.
When bit RDRF in SSR is set to 1, RXI is requested. When any of SSR bits OER, FER, or PER is
set to 1, ERI is requested. These two interrupt requests occur during the receiving of data.
Details on interrupts are given in section 3.3, Interrupts.
10. Serial Communication Interface
Rev.3.00 Jul. 19, 2007 page 305 of 532
Vector Address
H'0024
REJ09B0397-0300