Table of Contents
Advertisement
10. Serial Communication Interface
2. When an SCK
function is switched from clock output to general input/output
3
When stopping data transfer,
a. Issue one instruction to clear bits TE and RE in SCR3 to 0 and to set bits CKE1 and CKE0
to 1 and 0, respectively.
b. Clear bit COM in SMR to 0
c. Clear bits CKE1 and CKE0 in SCR3 to 0
Note that special care is also needed here to avoid an intermediate level of voltage from being
applied to SCK
.
3
Caution on Switching TxD Function: If pin TXD is used as a data output pin by SCI3 in
synchronous mode and is then switched to a general input/output pin (a pin with a different
function), the pin outputs a high level signal for one system clock (φ) cycle immediately after it is
switched.
Rev.3.00 Jul. 19, 2007 page 310 of 532
REJ09B0397-0300
Advertisement
Table of Contents
