Using Subscripts I And J - YASKAWA MP2100 Series User Manual

5. Addresses
Addresses are used only for pointer designations.
MF00200 to MF00228 are used as the parameter table in the following example.
MF00200～MF00228をパラメータテーブルとして使用します。
MW00200 to MW00204 are used as the parameter table in the following example.
MF00200～MF00204をパラメータテーブルとして使用します。
Parameter table leading
address

6.4.4 Using Subscripts i and j

Two subscripts, i and j, are used for modifying relay numbers and register numbers. i and j have exactly the same
function.
An example of each register data type is explained below.
(1) Subscripts Attached to Bit Data
When a subscript is attached to bit data, the value of i or j is added to the relay number. For example, if i = 2,
MB000000i will be the same as MB000002. If j = 27, MB000000j will be the same as MB00001B.
(2) Subscripts Attached to Integer Data
When a subscript is attached to integer data, the value of i or j is added to the register number. For example,
if i = 3, MW00010i will be the same as MW00013. If j = 30, MW00001j will be the same as MW00031.
(3) Subscripts Attached to Double-length Integer Data
When a subscript is attached to double-length integer data, the value of i or j is added to the register number. For
example, if i = 1, ML00000i will be the same as ML00001. ML00000j when j = 0, and ML00000j when j = 1 will
be as follows:
Error input value
MF00200
偏差入力値
PID MA00200
Parameter table leading
パラメータテーブル
address
先頭アドレス
Input value
MW00200 入力値
LAG MA00200
パラメータテーブル
先頭アドレス
2
MB000000i
J
00030
MW00001j
ML00000j when j = 0: ML00000
J=0のときML00000J： ML00000
ML00000j when j = 1: ML00001
J=1のときML00000J： ML00001
⇒MF00022
⇒MW00022
LAG output value
LAG出力値
MB0000002
I
Equivalent
等価
MW00031
Equivalent
等価
Upper-place
word
上位ワード
MW00001
MW00002
6.4 Registers
PID output value
PID出力値
Lower-place
word
下位ワード
MW00000
MW00001
6
6-27