005-286 Dadf Feed Out Sensor Failure Rap - Xerox WorkCentre 5222 Service Manual

A B
Measure the voltage between the DADF PWB
Flag 5). The voltage is approx. +24VDC.
Y N
Replace the DADF PWB (PL 15.3).
Replace the DADF Nudger Motor (PL
PWB (PL 15.3).
Replace the DADF PWB (PL 15.3).
Status Indicator Raps
005-285, 005-286
(PL 15.3) P786-1 (+) and GND (-) (BSD 5.2
15.6). If the problem persists, replace the DADF

005-286 DADF Feed Out Sensor Failure RAP

During document transport, before the DADF Feed Out Sensor turned Off, the DADF Pre Reg-
istration Sensor turned Off.
Initial Actions
Refer to BSD 5.4.
Procedure
Execute Component Control[005-205]. Actuate the DADF Feed Out Sensor
paper. The display changes.
Y N
Check the connections of
rectly.
Y N
Connect P/J769 and P/J758.
Check the wire between J769 and J758 for an open circuit or a short circuit (BSD 5.4
13/Flag 14). The wire between J769 and J758 is conducting without an open circuit
or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB P758-1 (+) and GND (-) (BSD 5.4
14). The voltage is approx. +5VDC.
Y N
Replace the DADF PWB
Measure the voltage between the DADF PWB P758-3 (+) and GND (-) (BSD 5.4
13). Actuate the DADF Feed Out Sensor with paper. The voltage changes.
Y N
Replace the DADF Feed Out Sensor
Replace the DADF PWB (PL
Execute Component Control [005-206]. Actuate the DADF Pre Registration Sensor
with paper. The display changes.
Y N
Check the connections of
rectly.
Y N
Connect P/J781 and P/J761.
Check the wire between J781 and J761 for an open circuit or a short circuit (BSD 5.4
3/Flag 4). The wire between J781 and J761 is conducting without an open circuit or
a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB P761-10 (+) and GND (-) (BSD 5.4
4). The voltage is approx. +5VDC.
A
February, 2008
2-76
P/J769 and P/J758. P/J769 and P/J758
(PL 15.3).
(PL 15.9).
15.3).
P/J781 and P/J761. P/J781 and P/J761
WorkCentre 5225, 5230
(PL 15.9) with
are connected cor-
Flag
Flag
Flag
(PL 15.7)
are connected cor-
Flag
Flag
Launch Version