012-231 Puncher Home Sensor On Fail - Xerox WorkCentre 5222 Service Manual

012-231 Puncher Home Sensor ON Fail

BSD-ON:15
The Puncher Home Sensor did not turn ON within the specified time after the Puncher Motor
started running.
Initial Actions
Check the following:
• Puncher Home Actuator for deformation
• Puncher Home Sensor for proper installation
• Puncher Home Sensor connectors
• Puncher Motor for proper operation
• Puncher Motor connectors
Procedure
Enter Component Control [12-074] and [12-078], Puncher Motor
Start. The Puncher Motor runs.
Y N
Select Stop. Check circuit of the Punch Motor. Refer to BSD 12.15 to troubleshoot the
Circuit.
Select Stop. Select [12-271], Puncher Home Sensor
sor with a piece of paper. The display changes.
Y N
Go to BSD 12.15. Check circuit of the Puncher Home Sensor.
Select Stop. If the problem continues, replace the Finisher Main PWB
Launch Version
WorkCentre 5225, 5230
(PL 23.5), alternately. Select
(PL 23.5). Select Start. Actuate the sen-
(PL 23.16).
February, 2008
2-131
Status Indicator Raps
012-231