012-243 Booklet Folder Home Sensor On Fail - Xerox WorkCentre 5222 Service Manual

012-243 Booklet Folder Home Sensor ON Fail

BSD-ON:12.17
Folder Home Sensor is not turned on after the lapse of 500ms from Motor ON while Booklet
Knife is returning to Home.
Initial Actions
• The Folder Home Sensor for improper installation
• The Folder Home Sensor connectors for connection failure
• The Booklet Fold Knife Motor connectors for connection failure
• The Knife drive mechanism for a foreign substance
Procedure
Manually move the Booklet Tamper to both ends. Enter
Knife Motor FWD] and [013-023, Folder Knife Motor REV] alternately. Select Start. The
Booklet Folder Roll Motor energizes.
Y N
Select Stop. Check continuity between the Booklet Folder Knife Motor and the Booklet
PWB and between the Booklet PWB and the Finisher PWB. The continuity check is
OK.
Y N
Repair the open circuit or short circuit.
Replace the Booklet Folder Knife Motor
Booklet PWB (PL 23.21). If the problem persists, replace Finisher PWB
Select Stop. Select [13-101, Folder Home Sensor]. Select Start. Block/unblock the Folder
Home Sensor. The display changed.
Y N
Select Stop. Check continuity between the Folder Home Sensor and the Booklet PWB
and between the Booklet PWB and the Finisher PWB. The continuity check is OK.
Y N
Repair the open circuit or short circuit.
Replace the Folder Home Sensor (PL
let PWB (PL 23.21). If the problem persists, replace Finisher PWB
Select Stop. If the problem continues, replace the Finisher PWB
Status Indicator Raps
012-243
Component Control [013-022, Folder
(PL 23.15). If the problem continues, replace the
(PL 23.16).
23.15). If the problem continues, replace the Book-
(PL 23.16).
(PL 23.16).
February, 2008
2-132
Launch Version
WorkCentre 5225, 5230