005-906 Cvt Feed Sensor Static Jam Rap - Xerox WorkCentre 5222 Service Manual

005-906 CVT Feed Sensor Static JAM RAP

Paper remains on the DADF Feed Out Sensor.
Initial Actions
• Refer to BSD 5.4.
• Remove the paper.
Procedure
Execute Component Control[005-205 DADF Feed Out Sensor]. Actuate the DADF Feed Out
Sensor (PL 15.9) with paper. The display changes.
Y N
Check the connections of P/J769 and P/J758.
rectly.
Y N
Connect P/J769 and P/J758.
Check the wire between J769 and J758 for an open circuit or a short circuit (BSD 5.4
13/Flag 14). The wire between J769 and J758 is conducting without an open circuit
or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB P758-1 (+) and GND (-) (BSD 5.4
14). The voltage is approx. +5VDC.
Y N
Replace the DADF PWB (PL 15.3).
Measure the voltage between the DADF PWB P758-3 (+) and GND (-) (BSD 5.4
Actuate the DADF Feed Out Sensor with paper. The voltage changes.
Y N
Replace the DADF Feed Out Sensor
Replace the DADF PWB (PL 15.3).
Replace the DADF PWB (PL 15.3).
Status Indicator Raps
005-906
P/J769 and P/J758 are connected cor-
Flag
(PL 15.9).
Flag
Flag
13).
February, 2008
2-80
Launch Version
WorkCentre 5225, 5230