Chrysler Conquest 1988 Service Manual page 238

CLUTCH
- Clutch Disc and Release Fork
_~
Es
Release bearing
f-
-Grease
Grease ----u
DCLOO!
J
Flywhel
Clutch disc
This surface has
a manufacturers
(9) The three dowels on the flywheel should be trght and e
undamaged.
The cover stamprng should be a snug frt on the dowels. ~c
(I O)lf the clutch assembly does not meet these requirements, it
should be replaced.
(1 IKheck the clutch releasekylrnder for fluid leakage.
(12Kheck the clutch releaseylinder boot tar damage.
SERVICE POINTS OF INSTALLATION
NOIQDAA
6. APPLICATION OF GREASE TO RELEASE FORK
Pack the release fork fulcrum hole and release cylinder _<
push rod hole with grease.
-
Specified grease: MOPAR Multi-Mileage Lubricant Part -I=
No. 2525035 or equivalent
5. APPLICATION OF GREASE TO CLUTCH BEARING
Pack grease in groove on release bearing I.D.
a=
Specified grease: MOPAR Multi-Mileage Lubricant Part
No. 2525035 or equivalent
-
3. INSTALLATION OF CLUTCH DISC / 2. CLUTCH COVER .-
ASSEMBLY
(1) If there are oils or greases on clutch facing and pressure = =
plate, thoroughly wipe away with a dry cloth.
(2) Lightly apply specified grease to clutch disc spline and I
main drive gear spline of transmission.
Specified grease: MOPAR Multi-Mileage Lubricant
Part No. 2525035 or equivalent
(3) Using clutch disc center guide (MD9982721, or main _
drive gear of transmis$ion, install clutchIdisc~-and clutch pi
cover assembly on flywheel.
(4) When installing clutch disc, be sure that surface having ;;
manufacturers stamped mark is on pressure plate si;de.
Caution
When installing transmission, do not shake it nor
install in such a manner that main drive gear is
unduly stressed.
Make sure that main drive gear enters clutch disc
squarely.