Chrysler Conquest 1988 Service Manual page 240

--__~-
1 FL-
_ __
INTRODUCTION
- How to Use This Manual
TO USE THIS MANUAL
NOOBAAF
receding page contams GROUP INDEX which
i lhe group title and group number.
All page numbers consist of two sets of digits
separated by a dash. The digits preceding the dash
Identify the number of the group. The digits follow-
ing the dash represent the consecutive page num-
ber wlthin the group. The page numbers~-can be
found on the top left or right of each page.
TEXT
Unless otherwrse specified, each service procedure
covers all models. Procedures coverings-specific
models are identified by the model codes or similar
designation (engrne type, transmission type, etc.). A
description of these designations is covered in this
unit under "VEHICLE IDENTIFICATION".
SERVICE PROCEDURES
The service steps are arranged in numerical order
and attentions to be paid in performing vehicle
service are described in detail in SERVICE POINTS.
DEFINITION OF TERMS
STANDARD VALUE
Indicates the value used as the standard for jzging
the quality of a part or assembly on inspection or the
value to which the part or assembly is corrected and
adjusted. It is given by tolerance.
LIMIT
Shows the standard for judging the quality of a part
or assembly on inspection and means the maximum
or rninlmum value within which the part or assembly
must be kept functlonally or in strength. It is a value
established outside the ranae of standard
value.
I--
Repalr kit or set parts are
shown.
(Only very
frequently
used parts are shown.)
Removal steps:
%Z _
The
numbers before part names correspond
to numbers In
the
illustration,
and lndlcate
the order of removal.
Disassembly steps:
The numbers before part names correspond
to numbers in the illustration, and Indicate
the order of disassembly.
Installation steps:
This IS provided If installation cannot be
made In the reverse order of "Removal
steps";
omiTted if installation In the reverse
order of "Removal steps" is possible.
Reassembly steps:
This is provided if reassembly cannot be
made tn the reverse order of "Disassembly
steps";
omrtted If reassembly in the re-
verse _prdeJ of "Disassembly steps" is
possible.
Classtflcatton of b
SERVICE POINTS
l *
Rcmovar
. .
Installation
*+
Disassembly
l .
Reassembly