Sorting The Data By Tool No - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
(4) Press the menu [Tool No. search] again.
Note
(1) If the tool number cannot be found, the message "Designated tool number not found" is displayed, and the input section
is not cleared.

5.5.8 Sorting the Data by Tool No.

Sort the tool management data in ascending order of tool numbers.
Operation method
(1) Display the tool management screen.
(2) Press the menu [Tool No sort].
(3) Press the [Y] or [INPUT] key.
Note
(1) During data sorting in ascending order of tool numbers, you cannot stop this sorting on the way.
(2) Once you have sorted the data in ascending order of tool numbers, you cannot return them to the previous sort order.
(3) If the same tool number is found multiple times, data is sorted in the order in which they are found from the top.
(4) If no tool number is set and if data is sorted, that line is skipped during display.
(5) The tool data is sorted for the currently displayed part system.
(6) During data sorting, you cannot operate on the screen. Operate the screen after data sorting.
IB-1501453-C
The search restart for the previously searched tool No.
After the search is completed, the operation message
"Search complete" appears.
The input column is cleared.
The designated tool number is searched from the tool
management data under the cursor position, and first-
found tool management data is displayed at the top.
The cursor is shifted to the head line of the display.
The tool management data list is displayed.
The operation message "Sorting of tool data is in prog-
ress" flashes during tool data sorting.
The operation message "Sorting of tool data is com-
plete" is displayed after the tool data has been sorted.
The tool management data is sorted in ascending order
of tool numbers, and they are displayed from the begin-
ning. The cursor moves to the top line.
The highlight of the menu [Tool No. sort] returns to nor-
mal.
176