Mitsubishi Electric C80 Series Instruction Manual page 28

C80 Series Instruction Manual
1 Outline of Menu Items
Menus
This displays the spindle load, NC axis load, etc., with a bar
graph. The display contents differ depending on MTB specifica-
LdMeter
tion.
This displays the current spindle tool number and the tool num-
ber that is standby to be used next. The display contents differ
Sp-stby
depending on MTB specification.
Displays the tool tip coordinate, handle interruption amount
(tool axis movement), and tool tip speed.
TipDisp
<Note>
This menu is displayed when any of the additional specifi-
cations (tool center point control, tool length compensation
along the tool axis, tool handle feed & interruption, inclined
surface machining command, 3-dimensional tool radius
compensation (tool's vertical-direction compensation) or 3-
dimensional manual feed) is valid.
This displays the command rotation speed and actual rotation
speed values of all spindles.
All Sp
This switches the counter display to replace the currently dis-
played axis.
Next Ax
This enlarges the counter to display all axes.
Cnt exp
An arbitrary value can be set in the relative position counter.
Cnt set
This executes a manual numerical value command.
MST
Setup screen (Setup)
Menus
This sets tool compensation amount.
Depending on the setting of the parameter "#1037 cmdtyp",
there are three types of tool compensation: tool compensation
Offset
type I/II (M system only), and tool compensation type III.
The number of tool compensation sets to be designated or
displayed varies depending on the additional specifications.
This executes tool measurement.
The distance from the basic point to the measurement point is
T-meas
measured by moving the tool to the measurement point manu-
ally, and this value can be set as the tool offset amount.
<Note>
This menu is displayed when the parameter "#8932 Hide
measure scrn" is set to "0".
This registers a tool.
A tool No. is assigned to each tool to make the tools installed
T-reg on the machine recognizable to the NC.
The tool No. is registered corresponding to the magazine pot
and spindle where that tool is installed, and the standby loca-
tion.
Details
Details
3
Reference
9.2.10 Load Meter Display
9.2.11 Spindle, Standby Display
9.2.12 Tool Center Coordinate Display
9.2.13 All Spindles' Rotation Speed Dis-
play
9.2.4 Switching the Spindle No. to be
Displayed on Counter
9.2.6 Counter All-axis Display
8.2 Counter Setting
8.4 Manual Numerical Value Command
Reference
5.4 Setting Tool Compensation Amount
(Tool Offset Screen)
5.3 Measuring a Tool (Tool Measure-
ment Screen)
5.2 Registering a Tool (Tool Registra-
tion Screen)
IB-1501453-C