C80 Series Instruction Manual
4 Inputting and Outputting a Machining Program
(12) The transfer range from the external device other than serial to NC memory will change depending on the value set
in the parameter "#19006 EOR Disable".
<When the parameter "#19006 EOR disable" is set to "0">
The head line will not be transferred.
Up to "%" in the second line onward will be transferred, and data after "%" will not be transferred.
If there is no "%", all data will be transferred.
<When the parameter "#19006 EOR disable" is set to "1">
All file contents will be transferred.
(13) When a wildcard "*" is designated for the file to be transferred, the transfer is executed excluding the programs which
are subject to the edit lock according to the status of Edit lock B and C.
(14) If the device shown below and the directory are designated for the transfer destination, the following operation is
performed depending on conditions.
When an existing file is designated: The file is transferred with a temporary file name, and changed to the designated
file name after transfer processing has been completed.
When a new file is designated: A new file is transferred with a temporary file name, and changed to the designated
file name after transfer processing has been completed.
(1) Transfer destination device: Memory
Directory: Machining program
(2) Transfer destination device: memory card, USB memory
A temporary file is designated by the file name that consists of 11 digits, beginning with the symbol "~".
After transfer is terminated properly, the temporary file is changed to the designated file name.
A temporary file remains in the cases below, but can be deleted in the same way as for a normal file.
When the transfer has terminated abnormally, for example, because the destination's capacity became full.
When the transfer has been interrupted.
107
IB-1501453-C