Mitsubishi Electric C80 Series Instruction Manual page 163

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Menus (Manual tool length measurement 1 (Simple operation mode))
Menus
The following value is written as the tool compensation amount, and the wear is cleared to "0".
Offset
write
Tool compensation amount = "Measure posn" value - "Prg zero offset (L)" value
When the tool offset is written, the "Measure posn" and "Prg zero offset (L)" are cleared. The cursor
moves to the tool compensation data.
The offset cannot be written in the following state. The operation message - "Can't write compensation
data" is displayed.
(a) When the menu [Offset number] is highlighted
(b) During wear data display
(c) When the measurement axis is not selected
If the tool compensation amount is outside the setting range, the offset writing fails. The operation
message "Setting error" is displayed.
<Note>
When the parameter "#8924 MEAS. CONFIRM MSG" is set to "1", the menu "Offset write" is high-
lighted and confirmation message "OK? (Y/N)" is displayed. When you press the [Y] (or [INPUT])
key, the measurement position is written as the tool compensation amount. When you press any
other key, the offset is not written. At this time, menu highlighting is canceled and the operation
message is erased.
If you press the menu [Offset Write] again during operation message display, the reverse display
is released and the operation message is also erased.
When the compensation No. is set and the [INPUT] key is pressed, the tool compensation data with that
Ofs No
number at its head appears.
search
This operation will not change the column where the cursor is placed.
If this operation is carried out with the cursor placed at "Prg zero offset (L)", the cursor will remain dis-
played at "Prg zero offset (L)".
Select the axis to measure. The menu is highlighted when it is selected. Multiple axes can be selected.
Measure
To cancel, press the menu key again or press [Cancel value]. (*1)
X
Select the axis to measure. The menu is highlighted when it is selected. Multiple axes can be selected.
Measure
To cancel, press the menu key again or press [Cancel value]. (*1)
Z
Select the axis to measure. The menu is highlighted when it is selected. Multiple axes can be selected.
Measure
To cancel, press the menu key again or press [Cancel value]. (*1)
C
Wear data is displayed in tool compensation data.
Wear
data
Tool length data is displayed in tool compensation data.
Length
This mode is enabled when turning ON the power.
data
This cancels displaying the value of the measurement result and "Prg zero offset (L)". The cursor moves
Cancel
from "Prg zero offset (L)" to the tool compensation data.
value
If any mode other than "Manual tool length measurement I" is selected, this menu will be grayed out and
non-selectable.
(*1) The axis name to be displayed follows the parameter "#1022 axname2".
Note
(1) The data displayed on the tool offset screen are not linked with the tool offset data on the tool measurement screen. (If
the tool measurement screen is opened with tool wear data shown on the tool offset screen, the wear data will not al-
ways appear on the tool measurement screen.)
IB-1501453-C
Details
138