Mitsubishi Electric C80 Series Instruction Manual page 125

C80 Series Instruction Manual
4 Inputting and Outputting a Machining Program
Display items
Display items
(1) Device, directory, file
name setting area
(2) Input/compare data dis-
play
(3) Guidance display area This displays the device name shortcut key.
(4) Process progress dis-
play section
(5) Capacity display section
(*1)(*2)
(6) List display section
(7) Input section
IB-1501453-C
This sets the device, directory, and file name for which the transmission, compare, and
erase functions are used. When the number of characters exceeds the display possi-
ble number (directory: 63 in three lines, file name: 42 in two lines), the excess is not
displayed.
As for the device and directory, the setting values are retained even when the power
is turned OFF.
This displays data that is being transferred or compared. If an error occurs while com-
paring data, the block for which the error occurred is displayed.
This displays the details and data input/output direction for the process currently being
performed.
This displays the file (machining program) registration count information and memory
capacity information for the selected device.
Prog entry: Displays the number of programs that are already registered as the user's
machining programs.
Remain: This displays the remaining number of programs that can be registered.
When memory is selected as the device, the total of the number of programs regis-
tered and the remainder is the maximum number of registrations set in the specifica-
tions.
Memory size: Displays the capacity that is already registered as the user's machining
programs.
Remain: Displays the remaining capacity that can be registered.
When memory is selected, the total of the memory capacity and the remaining ca-
pacity is used as the maximum memory capacity defined in the specifications.
This displays the directory contents list (directory and file name) of the device A or B
where the cursor is currently located.
When the menu [Commentnondisp] is highlighted, the [Date/Comment] column is not
displayed. Up to 32 characters are displayed in the file name column.
File name:
When "Memory" is selected for the device, this displays the file name (program
No.) of the machining programs already registered. The file names are displayed
in order from the smallest number, from 1 to 99999999.
When a device other than memory is selected, this displays the file name and di-
rectory to be included in the directory that is set in the current setting column.
When the number of characters exceeds the maximum (13 characters with the
comment column, 32 characters without the comment column), the excess is in-
dicated as "*".
Size:
This displays the size of each file. (The number of characters in the machining
program when the memory is selected for the device.)
When directory is selected, this displays "DIR".
Date/Comment:
This displays the comment (up to 19 alphanumeric characters and symbols) of
each file.
The date which the file is updated is displayed for the memory card or USB mem-
ory.
When the comment of the NC memory exceeds the number of display characters
(19 characters), the exceeded part is not displayed. The excess is not abbreviat-
ed to "*".
This displays the input key.
100
Details