Mitsubishi Electric C80 Series Instruction Manual page 362

C80 Series Instruction Manual
9 Machining a Workpiece
INPUT search
By pressing [INPUT] key when it is in the normal status (not being in status such as editing or character searching, etc.),
operation search of the selected part system is carried out starting from the block that has the cursor.
This is enabled when "1" is set to the parameter "#11031 Cursor pos search".
(1) Carry out the operation search to find the program to
carry out the cursor position search.
(2) Press the menu [Edit].
(3) Move the cursor to the block to be carried out the cur-
sor operation search.
(4) Press the [INPUT] key.
Note
(1) When operating character string search, string replace, cursor on input unit, or editing it will not start cursor position
search by pressing [INPUT] key.
(2) A selection part system operation search can be carried out using the block with the cursor as the top.
(3) Operating search program will be the program that was searched when program edit window was open.
(4) Cursor position search is disabled during automatic operation or restart search. However, it is enabled when the param-
eter "#11039 Cusr pos srch type" is 1 even if the operation is under single block stop. For details, refer to "Search during
single block stop" in "9.5.1 Program Editing".
(5) When MDI program is displayed, the block with the cursor will be set for MDI by pressing [INPUT] key.
(6) If the [INPUT] key is pressed when the data protection is valid, the cursor position search will be executed without dis-
playing the message "Data protect", and the message "Search completed" will appear upon completion.
(7) If the INPUT key is pressed during automatic operation or restart search while the program currently being displayed is
not in a selected part system, message "Executing automatic operation" or "Program restarting" is not displayed. The
cursor position search is carried out, and message "Search completed" is displayed.
(8) If the N number of the block to be searched exceeds the maximum value or is set to "0", it causes a search error in all
blocks that belong to the N number.
(9) If characters other than digits follow "N" of the block to be searched, "N**" of the program is handled as a normal block,
not a sequence number. Therefore, if the target block is searched, it is handled as a block that belongs to the previously
searched N number.
The program edit window appears.
The program is displayed starting from the block current-
ly searched.
(During automatic operation, the program is displayed
from its top.)
Operation search is carried out starting from the block
that the cursor is positioned.
During the search "Searing" will display blinking.
When the search is completed, "Search completed" is
displayed.
337 IB-1501453-C