Mitsubishi Electric C80 Series Instruction Manual page 328

C80 Series Instruction Manual
9 Machining a Workpiece
<L system>
(1)
(2)
(3)
(4)
Even if operating area is switched in the 2-part system simultaneous display, the position of the pop-up window will not
change. It is always displayed at the bottom of the screen.
Display items
Display items
(1) G modal list
The list below shows the G command modal status of the currently executed groups 1
to 20.
Each item displays the following information.
G00: Displays the G command modal status of the currently executed group 1.
G17: Displays the G command modal status of the currently executed group 2.
: Displays the G command modal status of each group in sequence.
G43.1: Displays the G command modal status of the currently executed group 19.
303
Details
(6)
(5)
IB-1501453-C