Mitsubishi Electric C80 Series Instruction Manual page 82

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Precautions for editing machining program
(1) An error occurs if a nonexistent program No. is set.
(2) If the selected program is running or program restarting, it can be displayed but not edited.
An error occurs when the data is set or the [INPUT] key is pressed.
(3) The fixed cycle program list is displayed when the parameter "#1166 fixpro" is set to "1".
(4) Editable size differs depending on each device. When the editable size is exceeded, the operation message "Can't edit
because of size over" appears.
(5) "Loading" is displayed in flickering until the file is opened.
(6) Editing is not possible for a program with 33 or more file name characters.
(7) When the program in search was edited, the program is searched again as follows depending on the last operation.
Search -> Edit: The position in which ONB is displayed is searched again.
Search -> Reset 1-> Edit: The program top is searched again.
Search -> Reset 2-> Edit: The search is not executed. If a program was added or deleted, the search position may shift.
Search -> Reset & Rewind -> Edit: The program top is searched again.
(8) If the protection level ("Program edit" data output) designated on the protection setting screen is higher than the current
operation level, the machining program cannot be opened (message "data protection" is displayed). However, if the pro-
tection level is set to a higher value on the protection setting screen while a machining program remains opened, the
machining program is kept opened even after the display has returned to the edit screen. To hide the machining program
after changing the protection level, press the menu [Close] to close the machining program, and change the protection
level on the protection setting screen. For details, refer to "2.8 Changing the Operation Level (Protect Setting Screen)".
(9) Display will be changed as follows depending on the value set in the user parameter "#19006 EOR Disable".
<When the parameter "#19006 EOR Disable" = "0">
When a file including "%" is opened in the edit screen, characters up to "%" will be displayed. By saving the file,
characters after "%" will be discarded.
When a file not including "%" is opened, "%" will be displayed at the end of the edit screen. By saving the file,
"%" will also be saved.
<When the parameter "#19006 EOR Disable" = "1">
The contents of a file is displayed on the edit screen as it is.
When a file whose last character is other than "%" is opened, "%" will be displayed at the end of the edit screen.
"%" will be saved by saving the file. For example, if the end of the file is "%" + "CRLF", an extra "%" will be added
at the end.
"Line copy" and "Line clear" can be made at the lines other than the last line which includes "%".
57 IB-1501453-C