Mitsubishi Electric C80 Series Instruction Manual page 439

C80 Series Instruction Manual
11 Performing a Backup Operation
(1) Press the menu [Area change] to select file setting column A.
(2) Designate the transfer source device and directory.
(3) Designate the file which consists of two or more machining programs.
(4) Press the menu [Area change] to select file setting column B.
(5) Designate the transfer direction device (memory).
(6) Press the menu [Dir] - [Program all].
When the file name is designated, only the top program of transfer source is stored in the designated file.
For example of "Example of "the external device -> NC memory" of machining program batch transfer", when "TEST-
CUT" is designated as the transfer direction file name, the top program is transferred as not "1000" but "TESTCUT".
(7) Press the menu [Transfr A→B].
(8) Press the [Y] or [INPUT] key.
When the same machining program already exists in transfer direction device, the operation message "Overwrite this
file?(Y/N)" appears.
The transferring the following program is continued by selecting [Y] or [N] key.
(9) Press the menu [Compare A:B].
Note
(1) When programs are input in a batch to NC memory, always specify "Program batch" to NC memory directory as transfer
direction. If "Program batch" is not specified, one file is transferred (No batch).
(2) When the program which is subject to edit lock exists in transfer source, the message "Edit lock B" or "Edit lock C" ap-
pears, and transfer is interrupted. When the program which is not subject to edit lock is transferred, delete the program
which is subject to edit lock in transfer source. (Refer to "11.8.3 Edit Lock B and C".)
(3) When the protection of the machining program is valid, the program cannot be transferred/verified. (Refer to "11.8.4
Data Protection Keys".)
(4) During the automatic operation, the program in program restart cannot be overwritten. The operation message "Execut-
ing automatic operation" or "Program restarting" appears, and transfer is interrupted.
(5) The first line of the transfer source file is ignored.
IB-1501453-C 414