Executing Restart Search (Restart Type 1) - Mitsubishi Electric C80 Series Instruction Manual
Hide thumbs
Also See for C80 Series:
- Manual (749 pages) ,
- Maintenance manual (162 pages) ,
- Connection and set up manual (304 pages)
Table of Contents
Advertisement
C80 Series Instruction Manual
9 Machining a Workpiece
9.3.6 Executing Restart Search (Restart Type 1)
When feed hold has been applied and reset because the tool has broken, etc., restart with Restart type 1.
When the following conditions are met, the program search is executed across all part systems in batch.
The parameter "#1285 ext21/bit0" (Multi-part system program management) is set to "1".
The parameter "#1285 ext21/bit1" (Program search type switch) is is set to "1".
The machining program is stored in the device [Memory].
ONBP is not used.
Operation method
(Example) When tool breakage during execution of O1000 N7 occurred, and restarting from the O1000 N6 block
(1)
Press the feed hold button and retreat to the tool
change position by manual means or MDI. Press the
reset key and suspend the present processing.
(2)
Replace with a new tool.
(3)
Press the main menu [Reserch].
(4)
Press the [Type 1].
Set the position to restart search in the setting area.
(5)
Press the [INPUT] key or the menu [Search exec].
(*1) The maximum number of digits is eight for the sequence No. and five for the block No.
Note
(1) When the sorting of tool data is in progress, the operation message "Sorting of tool data is in progress" appears, and
the search cannot be executed.
IB-1501453-C
The sub-menu is displayed.
The main screen for restart search appears as a pop-up
window.
Delimit the ONB number in the setting area using /.
<When O No. was attached>
The main or sub program is targeted.
(Example) 1000/6/0
<When O No. was not attached>
The program currently searched is targeted.
(Example) /6/0
<Note>
When the [INPUT] key is pressed without entering
data in the input area, restart search will be carried
out for the last executed block.
Restart search is executed. (*1)
The message "Executing restart search" appears during
the search process, and the message "Restart search is
completed" appears when completed.
Each axis' restart position and the restart remaining dis-
tance are displayed.
When the menu [MSTB history] is pressed, the MSTB
history screen will open as a pop-up window, and the M,
S, T, B command used in the machining program will be
listed.
324
Advertisement
Table of Contents
